Publicaciones en las que colabora con Pedro Ginés Vicente Quiles (26)

2024

  1. Effect of three-orifice baffles orientation on the flow and thermal–hydraulic performance: Experimental analysis for net and oscillatory flows

    Applied Thermal Engineering, Vol. 236

2023

  1. Enhanced thermal-hydraulic performance in tubes of reciprocating scraped surface heat exchangers

    Applied Thermal Engineering, Vol. 220

2021

  1. Baffled tubes with superimposed oscillatory flow: Experimental study of the fluid mixing and heat transfer at low net Reynolds numbers

    Experimental Thermal and Fluid Science, Vol. 123

2020

  1. Experimental analysis of flow pattern and heat transfer in circular-orifice baffled tubes

    International Journal of Heat and Mass Transfer, Vol. 147

2019

  1. Experimental study of a modified evaporative photovoltaic chimney including water sliding

    Renewable Energy, Vol. 134, pp. 161-168

  2. Flow pattern analysis in a rotating scraped surface plate heat exchanger

    Applied Thermal Engineering, Vol. 160

2018

  1. Experimental study of heat transfer to non-Newtonian fluids inside a scraped surface heat exchanger using a generalization method

    International Journal of Heat and Mass Transfer, Vol. 118, pp. 75-87

  2. On the early onset of transition in circular-orifice baffled tubes: an experimental study

    Proceedings of the International Symposium on Turbulence, Heat and Mass Transfer

2017

  1. Photovoltaic Evaporative Chimney as a new alternative to enhance solar cooling

    Renewable Energy, Vol. 111, pp. 26-37

2016

  1. Flow pattern of non-Newtonian fluids in reciprocating scraped surface heat exchangers

    Experimental Thermal and Fluid Science, Vol. 76, pp. 306-323

2015

  1. Generalized reynolds number and viscosity definitions for non-newtonian fluid flow in ducts of non-uniform cross-section

    Experimental Thermal and Fluid Science, Vol. 64, pp. 125-133

2014

  1. Transient modeling of high-inertial thermal bridges in buildings using the equivalent thermal wall method

    Applied Thermal Engineering, Vol. 67, Núm. 1-2, pp. 370-377

2013

  1. Effect of the axial scraping velocity on enhanced heat exchangers

    International Journal of Heat and Fluid Flow, Vol. 44, pp. 265-275

2012

  1. The influence of artificial roughness shape on heat transfer enhancement: Corrugated tubes, dimpled tubes and wire coils

    Applied Thermal Engineering, Vol. 35, Núm. 1, pp. 196-201

2011

  1. Flow field and heat transfer investigation in tubes of heat exchangers with motionless scrapers

    Applied Thermal Engineering, Vol. 31, Núm. 11-12, pp. 2013-2024

  2. Flow pattern assessment in tubes of reciprocating scraped surface heat exchangers

    International Journal of Thermal Sciences, Vol. 50, Núm. 5, pp. 803-815

  3. Performance evaluation of a zero-fouling reciprocating scraped-surface heat exchanger

    Heat Transfer Engineering, Vol. 32, Núm. 3-4, pp. 331-338

2008

  1. Notas sobre simulación numérica de flujos de fluidos

    Universidad Politécnica de Cartagena

2007

  1. Enhancement of laminar and transitional flow heat transfer in tubes by means of wire coil inserts

    International Journal of Heat and Mass Transfer, Vol. 50, Núm. 15-16, pp. 3176-3189

  2. Flow pattern assessment in tubes with wire coil inserts in laminar and transition regimes

    International Journal of Heat and Fluid Flow, Vol. 28, Núm. 3, pp. 516-525