Ingeniería Térmica y Fluidos
Departamento
Pedro Ginés
Vicente Quiles
Investigador en el periodo 1999-2001
Publicaciones en las que colabora con Pedro Ginés Vicente Quiles (28)
2024
-
Effect of three-orifice baffles orientation on the flow and thermal–hydraulic performance: Experimental analysis for net and oscillatory flows
Applied Thermal Engineering, Vol. 236
2023
-
Enhanced thermal-hydraulic performance in tubes of reciprocating scraped surface heat exchangers
Applied Thermal Engineering, Vol. 220
2021
-
Baffled tubes with superimposed oscillatory flow: Experimental study of the fluid mixing and heat transfer at low net Reynolds numbers
Experimental Thermal and Fluid Science, Vol. 123
2020
-
Experimental analysis of flow pattern and heat transfer in circular-orifice baffled tubes
International Journal of Heat and Mass Transfer, Vol. 147
2019
-
Experimental study of a modified evaporative photovoltaic chimney including water sliding
Renewable Energy, Vol. 134, pp. 161-168
-
Flow pattern analysis in a rotating scraped surface plate heat exchanger
Applied Thermal Engineering, Vol. 160
2018
-
Experimental study of heat transfer to non-Newtonian fluids inside a scraped surface heat exchanger using a generalization method
International Journal of Heat and Mass Transfer, Vol. 118, pp. 75-87
-
On the early onset of transition in circular-orifice baffled tubes: an experimental study
Proceedings of the International Symposium on Turbulence, Heat and Mass Transfer
2017
-
Photovoltaic Evaporative Chimney as a new alternative to enhance solar cooling
Renewable Energy, Vol. 111, pp. 26-37
2016
-
Flow pattern of non-Newtonian fluids in reciprocating scraped surface heat exchangers
Experimental Thermal and Fluid Science, Vol. 76, pp. 306-323
2015
-
Generalized reynolds number and viscosity definitions for non-newtonian fluid flow in ducts of non-uniform cross-section
Experimental Thermal and Fluid Science, Vol. 64, pp. 125-133
2014
-
Transient modeling of high-inertial thermal bridges in buildings using the equivalent thermal wall method
Applied Thermal Engineering, Vol. 67, Núm. 1-2, pp. 370-377
2013
-
Effect of the axial scraping velocity on enhanced heat exchangers
International Journal of Heat and Fluid Flow, Vol. 44, pp. 265-275
2012
-
The influence of artificial roughness shape on heat transfer enhancement: Corrugated tubes, dimpled tubes and wire coils
Applied Thermal Engineering, Vol. 35, Núm. 1, pp. 196-201
2011
-
Flow field and heat transfer investigation in tubes of heat exchangers with motionless scrapers
Applied Thermal Engineering, Vol. 31, Núm. 11-12, pp. 2013-2024
-
Flow pattern assessment in tubes of reciprocating scraped surface heat exchangers
International Journal of Thermal Sciences, Vol. 50, Núm. 5, pp. 803-815
-
Performance evaluation of a zero-fouling reciprocating scraped-surface heat exchanger
Heat Transfer Engineering, Vol. 32, Núm. 3-4, pp. 331-338
2010
-
Improvement in learning on fl uid mechanics and heat transfer courses using computational fl uid dynamics
International Journal of Mechanical Engineering Education, Vol. 38, Núm. 2, pp. 147-166
2008
-
Notas sobre simulación numérica de flujos de fluidos
Universidad Politécnica de Cartagena
2007
-
Enhancement of laminar and transitional flow heat transfer in tubes by means of wire coil inserts
International Journal of Heat and Mass Transfer, Vol. 50, Núm. 15-16, pp. 3176-3189