Publications (80)

2016

  1. Analysis of the impact of droplets onto water films in drift eliminators

    International Journal of Computational Methods and Experimental Measurements, Vol. 4, Núm. 1, pp. 24-32

  2. Effects of the aeration on the fluid dynamic behaviour of a multi-zone activated sludge system

    WASTE MANAGEMENT AND THE ENVIRONMENT VIII

  3. Flow pattern of non-Newtonian fluids in reciprocating scraped surface heat exchangers

    Experimental Thermal and Fluid Science, Vol. 76, pp. 306-323

  4. Hydraulic characterization of an activated sludge reactor with recycling system by tracer experiment and analytical models

    Water Research, Vol. 101, pp. 382-392

  5. Máquinas hidráulicas: teoría y problemas

    Universidad Politécnica de Cartagena

  6. Numerical analysis of the vacuum infusion process for sandwich composites with perforated core and different fiber orientations

    Journal of Sandwich Structures and Materials, Vol. 18, Núm. 4, pp. 415-444

  7. Study of the performance of an adiabatic cooling pad in an air cooler system

    Renewable Energy and Power Quality Journal, Vol. 1, Núm. 14, pp. 748-753

2015

  1. Experimental study of BIPV(Building integrated photovoltaics) modules running as solar passive air heaters for the regeneration of a desiccant wheel

    2015 AEIT International Annual Conference, AEIT 2015

  2. Generalized reynolds number and viscosity definitions for non-newtonian fluid flow in ducts of non-uniform cross-section

    Experimental Thermal and Fluid Science, Vol. 64, pp. 125-133

  3. Medida de la temperatura de pared en intercambiadores de calor de superficie rascada mediante termopares embebidos

    IX Congreso Nacional de Ingeniería Termodinámica: libro de actas. Cartagena, 3 al 5 de junio 2015 (Universidad Politécnica de Cartagena), pp. 1143-1152

  4. Numerical study and experimental validation of thewater films and the detachment of drops on drift eliminators

    Computational Thermal Sciences, Vol. 7, Núm. 2, pp. 167-180

  5. Numerical study of the vacuum infusion process for laminated composites with different fiber orientations

    Journal of Reinforced Plastics and Composites, Vol. 34, Núm. 3, pp. 196-212